HP Point of Sale rp5000 Getting Started page 26
Point of sale system
Hide thumbs
Also See for Point of Sale rp5000:
- Troubleshooting manual (78 pages) ,
- Hardware reference manual (63 pages) ,
- Management manual (47 pages)
Table of Contents
Advertisement
Getting Started
Diagnostic Front Panel LEDs and Audible Codes
Activity
Computer
powered off
automatically
and the Red
Power LED
flashes two
times, once every
second, followed
by a two-second
pause.
22
Possible
Beeps
Cause
None
Processor thermal
protection
activated:
A fan may be
blocked or not
turning.
OR
The heatsink/fan
assembly is not
properly attached
to the processor.
www.hp.com
Recommended
Action
1. Ensure that the
computer air vents
are not blocked and
the processor
cooling fan is
running.
2. Open hood, press
power button, and
see if the processor
fan spins. If the
processor fan is not
spinning, make sure
the fan's cable is
plugged onto the
system board
header. Ensure the
fan is fully/properly
seated or installed.
3. If fan is plugged in
and seated
properly, but is not
spinning, then
replace processor
fan.
4. Reseat processor
heatsink and verify
that the fan
assembly is properly
attached.
5. Contact an
authorized reseller
or service provider.
Getting Started
Advertisement
Table of Contents
