HP Point of Sale rp5000 Getting Started page 19
Point of sale system
Hide thumbs
Also See for Point of Sale rp5000:
- Troubleshooting manual (78 pages) ,
- Hardware reference manual (63 pages) ,
- Management manual (47 pages)
Table of Contents
Advertisement
Solving General Problems (Continued)
Problem
System does not
power on and the
LEDs on the front of
the computer are not
flashing.
Getting Started
Cause
System unable to
power on.
www.hp.com
Solution
Press and hold the power button
for less than 4 seconds. If the
hard drive LED turns green,
then:
1. Check that the voltage
selector, located on the
rear of the power supply, is
set to the appropriate
voltage. Proper voltage
setting depends on your
region.
2. Remove the expansion
cards one at a time until the
AUX LED on the system
board turns on.
3. Replace the system board.
OR
Press and hold the power button
for less than 4 seconds. If the
hard drive LED does not turn on
green then:
1. Check that the unit is
plugged into a working AC
outlet.
2. Open hood and check that
the power button harness is
properly connected to the
system board.
3. Check that both power
supply cables are properly
connected to the system
board.
Getting Started
15
Advertisement
Table of Contents
