Attenuating Input Channels - Yamaha DM1000 Owner's Manual
Digital production console
Hide thumbs
Also See for DM1000:
- Service manual (308 pages) ,
- Owner's manual (34 pages) ,
- Manual (30 pages)
Table of Contents
Advertisement
64
Chapter 6—Input Channels
C
CURVE
This area displays the current compressor curve.
D
TYPE
This field indicates the compressor type used by the currently-selected channel's com-
pressor (COMP/EXPAND/COMP (H)/COMP (S)).
Note: You cannot change the compressor type on this page. To change the compressor type,
recall a program that uses the desired compressor type from the compressor library.
E
Meters
These meters indicate the levels of the post-compressor signals and the amount of gain
reduction.
F
ON/OFF
The ON/OFF button turns the currently-selected Input Channel's compressor on or off.
G
PARAMETER section
These controls enable you to set the compressor parameters. (See page 320 for more
information on the parameters of each compressor type.)
Tip: You can store the compressor settings in the Compressor library, which features preset
programs that can be used for various applications (see page 175).
Attenuating Input Channels
To set the attenuator for each channel, press the SELECTED CHANNEL EQUALIZER
[DISPLAY] button repeatedly until the page listed below that contains the desired channels
appears.
- ATT 1-16 page
This page enables you to set the attenuators for Input Channels 1–16.
- ATT 17-32 page
This page enables you to set the attenuators for Input Channels 17–32.
- ATT 33-48 page
This page enables you to set the attenuators for Input Channels 33–48.
The parameters on these three pages (and the procedure for setting them) are the same.
Move the cursor to the knob for the desired Input Channel, then rotate the Parameter wheel
to set the amount of attenuation in the range of –96 dB to +12 dB. To reset the attenuation
amount to 0 dB, move the cursor to the desired knob, then press the [ENTER] button.
DM1000—Owner's Manual
Advertisement
Table of Contents
