Yamaha DM1000 Owner's Manual page 138
Digital production console
Hide thumbs
Also See for DM1000:
- Service manual (308 pages) ,
- Owner's manual (34 pages) ,
- Manual (30 pages)
Table of Contents
Advertisement
138
Chapter 11—Surround Functions
• SNAP TO SPL85........... Turning on this button resets the [MONITOR LEVEL] control
Note: The Surround Monitor Mute and Solo functions are reset to the default condition when
you change the Surround mode.
3 Move the cursor to the SET SPL button, then press [ENTER] to turn on the
button.
The volume setting of the [MONITOR LEVEL] control is calibrated to 85 dB SPL and
stored.
If you store the cinema standard level in this way, moving the cursor to the SNAP TO SPL85
button and pressing [ENTER] always restores the stored value, even after you adjust the
[MONITOR LEVEL] control.
Tip: When the SET SPL button is turned on, the standard value (85.0 dB ) indicated in the
MONITOR LEVEL box is applied to the stored [MONITOR LEVEL] control setting.
Using the Oscillator for Surround Monitor
The DM1000 features a dedicated Oscillator that enables you to check the output and sound
of the surround sound speakers. You can send the Oscillator signal to certain speakers or to
each speaker in turn. This function is useful when you wish to check the volume balance
and phase of the surround monitor speakers.
Tip: This Oscillator is available only for Surround monitoring.
1 Press the MONITOR [DISPLAY] button repeatedly until the Monitor | Surr
Setup page appears.
The SPEAKER SETUP section enables you to turn the Oscillator on or off and specify the
signal destination.
A
SPEAKER SETUP
You can select the Oscillator waveform and the speakers to which the Oscillator signal is
sent.
• OSC. .............................. This parameter selects the Oscillator waveform.
• ON/OFF ........................ This button turns the Oscillator on or off.
• ROTATE ........................ When the ROTATE button is on, the Oscillator signal is output
•
DM1000—Owner's Manual
setting to the value stored by the SET SPL85 button.
1
by each speaker in turn, with an interval of five seconds (3-sec-
ond signal and 2-second pause).
(Speaker) buttons.......................These buttons turn the Oscillator on or off for
each speaker.
Advertisement
Table of Contents
