Advertisement
Line Out
When feeding the output signal to other amplifier, connect these
jacks to the AUX input jacks of that amplifier.
What is MQJS?
The MQJS mechanism
is designed to seek blank portions between sections of recorded tape, and then to automatically commence
playing from a blank portion.
In the RT-S933, the MQJS mechanism can jump up to 10 sections forward, or 9 sections backward,
and automatically start playing a selected tune.
Note:
Keep [AUTO REPEAT]
button @ in the 11 (out) position.
[TIMER/MQJS]
button @} may be in either one of oi or
2 position.
a Repeated Listening to a Present Tune
(@) Put the tape into playback mode as described earlier under
"Listening to Tapes".
@ Press the [44REW/REVIEW]
button @.
a Jumping the Present Tune to the Next
a) Put the tape into playback mode as described earlier under
"Listening to Tapes''.
@ Press the [>> FF/CUE} button @.
In the above two cases it is not necessary to press the [MQJS]
button &.
# Jumping the Present Tune to Listen to 4th Tune Ahead
Stop
automatically
to
start
playing
from
the beginning
of this tune.
Present tune
1st tune
3rd tune
4th tune
d
D
®
Number
of blank portions between tunes (Number of jumped tunes, in
this case 3.)
@) Put the tape into playback
mode as described earlier under
"Listening to Tapes".
@) Press the [MQJS SET] button @ 3 times.
@ Then press the [»>FF/CUE]
button @.
= Jumping the Present Tune to Listen to the 4th Tune Back
Stop automatically to start playing
from the beginning of this tune.
Present tune
®
D
@ ——-@
Number of tunes jumped
in this case 4
Number of blank portions
between tunes
@) Put the tage into playback mode as described earlier under
'Listening to Tapes''.
@) Press the {MQJS SET] button & 4 times.
@ Then press the [44REW/REVIEW]
button &.
Note:
When the [MQJS SET] button
& was pressed incorrectly, press tha [{MQJS RESET] button @, perform the same procedure
again,
(nc
1. When
a blank
(non-recorded)
portion
of tape is too short
(less than 5 seconds).
2. When a blank portion of tape contains noise.
3. When
a tune
contains
pianissimo
(very
soft sound)
or
silence,
4,'When the batteries have run down.
5. When
MQJS
button
is pressed accidentally without press-
ing the [»PLAY]
button @ (in this case, the tape will be
en
switched to fast forward or rewind mode).
6. When
the [AUTO
REPEAT]
button
is placed in the .o
({N) position.
7. When
the
[44REW/REVIEW]
button
&
is pressed al-
most
immediately
after the start of a tune, or when
the
{>>FF/CUE]
button
& is pressed just before the end of
a tune
{in this case, the tune following the next will be
played instead of the next).
oe
« Procedure of Recording Tape for MOJS
@When
recordong
from
the
radio or via microphones,
make
the
blank
portions
between
each
recorded
portion
in the
following way:
G) At the end of a recording, keep pressing the [NPAUSE/
EDITOR}
button
@ letting the tape continue moving for at
4a
least 5 seconds.
@) Then release the [IIPAUSE/EDITOR] button & to stop the
tape.
@) After a commercia! or other unwanted announcements
have
finished, press the [®RECORD!
button & or [PPLAY]
button € again to start recording again.
Advertisement
