Table of Contents
Advertisement
Figure 33. Installing the I/O board
Steps
1. Align the ports on the I/O board to the port openings on the palm-rest and keyboard assembly.
2. Carefully slide and place the I/O board at an angle, on the palm-rest and keyboard assembly.
3. Align the screw holes on the I/O board to the screw holes on the palm-rest and keyboard assembly.
4. Replace the three screws (M2x3.5) that secure the I/O board to the palm-rest and keyboard assembly.
5. Connect the fingerprint reader cable to the connector on the I/O board and close the latch.
NOTE:
This step applies only to computers shipped with a fingerprint reader installed.
6. Connect the I/O-board cable to the connector on the I/O board and close the latch.
7. Close the display hinge downwards to align the screw holes of the left hinge to the screw holes on the palm-rest and
keyboard assembly.
8. Replace the three screws (M2.5x5) that secure the hinge to the palm-rest and keyboard assembly.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
After working inside your
computer.
72
Removing and installing Field Replaceable Units (FRUs)
Advertisement
Table of Contents
