Figure 22. Connecting the battery cable
Steps
1. Connect the battery cable to the connector on the battery and close the latch.
2. Route the battery cable through the routing guides on the battery.
Next steps
1. Install the battery.
2. Install the
base
cover.
3. Follow the procedure in
After working inside your
computer.
Installing the battery
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the battery and provides a visual representation of the installation procedure.
58
Removing and installing Field Replaceable Units (FRUs)