Canon SPEEDLITE 540EZ Service Manual page 20
Hide thumbs
Also See for SPEEDLITE 540EZ:
- Instruction book (37 pages) ,
- Manual (36 pages) ,
- Parts catalog (12 pages)
Table of Contents
Advertisement
Part 1: General Information
4. MAJOR CONTROLS AND INDICATORS
Flash exposure compensation amount/
Manual firing output level
Zoom (Focal Lengh) Position
Manual Zoom Indicator
* Extinguished in auto zoom mode.
Flash Exposure Compensation Indicator
Bounce Indicator
: Up/Left/Right Bounce
~~
Indicator
peas
hligh'
fi
ti
A-TTL, TTL Automatic Flash Mode
Y
Catenlig cnn unian
Manual Firing Mode
Multi-Firing (stroboscopic) Mode
m:
Distance values
ft: Distance values
* The user can select whether to
display meter or feet values by
setting the switch in the battery
chamber.
Coupling Range Display Bar
No. of bursts in multi-firing mode
Aperture value/Multi-firing frequency
Second-curtain sync mode
(*Extinguished during first-curtain
sync operation)
LCD Panel
(For Contents, refer to the above.)
Flash Mode Button
* Each press changes the mode
in the following sequence:
k ATTL PIM? MULTI 5
LCD Panel Illumination Button
* Illuminates the display for 8
seconds.
Zoom Button
¢ Each press changes the zoom
mode/position in the following
sequence:.
a
—MZOOM24 528
105<80 <70
< 50 <¢ 35
¢ Automatically sets to the 28mm
position when the wide panel is
positioned over the flash head.
At this time, "MZOOM 18mm' is
* Lights yellow-green during quick
firing operation
Main Switch
* Lights red at full charge
¢ Three positions available:
O: OFF
I: ON
SE: Flash automatically turns off
if no operation is performed within
90 seconds.
Flash Exposure Check Lamp
* Lights green for two seconds
if flash exposure is okay.
* Does not light if flash exposure
is insufficient.
Select/Set Button
¢ Activates the number-setting state to
enable selection of the flash exposure
compensation value, manual firing output
level, no. of bursts in multi-firing mode,
or multi-firing frequency.
Pressing this button causes the selected
value to start blinking, After the desired
i
aes
number is set using the plus and minus
buttons, pressing this button again locks
Sync Timing Switch Buttons
in the value (causing it to stop blinking
¢ Simultaneously pressing these
ang light steadily).
two buttons switches between
first- and second-curtain
synchronization timing.
Minus Button (-)
1
'
1
1
1
1
'
r
1
Figure 1-2 Major Controls and Indicators
1-13
Advertisement
Table of Contents
