Fault 33: Unknown Motor/Generator Fault - Toro Reelmaster 5010-H Diagnostic Manual
Hide thumbs
Also See for Reelmaster 5010-H:
- Service manual (335 pages) ,
- Operator's manual (128 pages) ,
- Installation instructions manual (12 pages)
Table of Contents
Advertisement
Fault 33: Unknown Motor/Generator Fault
InfoCenter Display:
Fault Description
An unknown motor/generator fault has occurred. An error in the fault reference table exists in the TEC-5002
software.
Circuit Description
All fault reference tables are stored in the non-volatile memory of the TEC-5002.
Conditions for Setting the Fault
Only an error in the TEC-5002 software can cause the TEC-5002 to set this fault.
Recommended Service Actions
Step 1: Verify that the fault repeats.
1.
Clear the system faults from the InfoCenter. Refer to
2.
Operate the machine.
Pass
The fault did not repeat. Go to
Note:
If the fault does not repeat, an isolated event has occurred.
Fail
The fault repeated. Contact the Toro Technical Assistance Center for additional guidance.
Note:
You must fix this software fault; accomplish the TEC-5002 software repair with direct
assistance from Toro.
_____FAULT
#33_____
Unknown
Clearing Faults from the InfoCenter (page
Returning the Machine to Service (page 22)
113
Fault
21).
and follow the steps listed.
- Quick Links:
- Fault 59: Main Contactor-Open Failure
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
