Removing The Rope Stopping Mechanism - Siemens SICHARGE D Operating Instructions Manual
Hide thumbs
Also See for SICHARGE D:
- Product information (93 pages) ,
- Operating instructions manual (32 pages) ,
- Commissioning manual (30 pages)
Table of Contents
Advertisement
Installation and mounting
5.5 Setting up the charging station
5.5.5.3
Removing the rope stopping mechanism
The following operating instruction shows how to remove the rope stopping mechanism of
the right charging point of the charging station. The procedure for the left charging point is
identical.
Figure 5-22 Removing the rope stopping mechanism
NOTICE
Danger of crushing by rope box
The rope is tensioned by a spring tension mechanism in the rope box. Avoid crushing and
burning. Pull the cable down on the cable clamp until the rope clamp is relieved. This allows
you to remove the rope clamp on the rope box.
Pull the cable at the cable clamp only until the rope clamp is relieved and free. If you pull too
far, the rope clamp may damage the pulleys in the pulley cross. Remove the rope stopping
mechanism with an 8 mm socket. Remove the pulley.
NOTE
Store aside rope clamp and pulley
If a repair is required – on the cable clamp or the charging cable for example – then you must
secure the rope on the rope box. Therefore, keep the rope clamp and pulley in a DIN A4
envelope in the document pocket of the charging station.
92
Operating Instructions, 11/2023, A5E50556539-AG
SICHARGE D
Advertisement
Table of Contents
