Prepos; Text Conversion Dcncc.ini; Camera Installation Import/Export; Introduction - Bosch DCN Manual

Table of Contents

Advertisement

External Interface Manual
9.2.7

PREPOS

Call pre-position (pp#) on camera (cam#).
Command Syntax
PREPOS cam# pp#
where:
cam#
pp#
Note that this command should restore a previously set camera position. This implies that the camera could
rotate, swivel and zoom to the appropriate position.
9.2.8

Text conversion DCNCC.INI

Each variable text, which is send to the Allegiant, will be converted. This because the Allegiant uses a
different character set then windows. This conversion table is located in the DCNCC.INI file (DCN-directory).
On the left side, the windows characters are given. On the right side, the equivalent of the used characters
are given. For example...
Char_E6=0x91
will result in a character 0x91 sent to the Allegiant, when a character 0xE6 is used in windows.
9.3

Camera installation import/export

9.3.1

Introduction

In the Camera installation application, it is possible to export and to import the camera installation data. This
section specifies the layout of such an import/export file.
9.3.2

Import/export file layout

The import/export file is composed of the following lines of data (in this order):

identification

camera definition
camera seat
assignment
9.3.2.1.
Identification
DCN CAMERA 8.0<SEP>filename<SEP>number of audience monitors<SEP>movement
time<SEP>screen line usage<SEP>camera override<SEP>number of camera
definitions<SEP>number of seat assigments<EOL>
Bosch Security Systems B.V. | 2004 April | External Interface Manual
Camera number. A decimal number in the range 0 - 255
Preposition number to be recalled. A decimal number in the range 0 -
255.
This section is the 1
This section consists of lines repeated for each camera
definition.
This section consists of lines for each seat assignment.
st
line in the file.
en | 39

Advertisement

Table of Contents
loading

Table of Contents