Table of Contents
Advertisement
Panasonic Digital Business System - Programming Manual
April 1997
Action When Other Party Is Busy
0#
Wait For Network Disconnect Signal
1#
Disconnect Without Waiting For Disconnect Signal
When an outgoing call on the DASS II channels receives busy the DBS can wait for the network to
send disconnect or disconnect without waiting for the network signal.
Display When Other Party Is Busy
0#
Display In Numbers
1#
Display In Characters
When the called party is busy the network will return status information to the DBS to show the
reason. The DBS can display the numeric code or brief text explaining the cause to the LCD of
keysets.
MC0 (Dial 9) Search
0#
Search DASS II Channels First
1#
Search Analogue Lines First
The DBS can search either the DASS II channels or analogue lines first when 9 is dialled to select
a line. If all lines of the preferred type are busy the search continues to the other lines.
DASS II Dialling Type
The DASS II signalling specification can be set for enblock ( all digits collected and sent in a single
message) or overlap (each digit is sent to the network as it is dialled).
The default setting of this step has been changed to Overlap dialling from this software level.
ISDN Protocol Selection
Selection of the ISDN protocol to be connected to the system. If two ISDN cards are fitted they
must both use the same protocol.
FF1 6# 1# 5# (0-1)#
FF1 6# 1# 6# (0-1)#
FF1 6# 1# 7# (0-1)#
FF1 6# 1# 8# (0-1)#
(0-1)#
0#
Enblock dialling
1#
Overlap dialling
FF1 6# 1# 9# (0-1)#
0# Euro ISDN
1# DASSII
48
Issue 15
ISDN 1.0
ISDN 1.0
ISDN 1.0
CPC-EX 1.0 / 1.5
CPC-EX v1.5
Advertisement
Table of Contents
