Table of Contents
Advertisement
iSitePower-M (MAP05A1, MAB05B1)
User Manual
Installing Modules and Cables for Battery Recharge
Use standard cables provided by Huawei to connect power modules and battery
modules. Do not use non-standard cables (such as extension cables and
interconnection cables). If BAT+ and BAT– cables are reversely connected, the
device will be damaged.
Step 1 For details about how to install a power module and battery module, see
Installing
Step 2 For details about how to install battery recharge cables, see
7.2 Installing Ground
power cables need to be installed),
and
Step 3 After the installation, refer to
installation.
----End
Battery Power-On and Commissioning
● Ensure that the charge process is supervised to prevent any abnormality.
● If a battery experiences an abnormality such as bulging or smoking, stop
● Ensure that only trained professionals perform recharge operations.
● When the battery SOC is 0%, the product cannot be activated by pressing and
● It is recommended that a battery be charged to 50% SOC during recharge.
Prerequisites
Power cables and signal cables are connected correctly.
Procedure
Step 1 Turn on the corresponding switch based on the scenario.
Issue 02 (2021-12-30)
–
Shell damage
–
Leakage
WARNING
Modules.
Cables,
7.6 Installing Cascading Signal Cables Between Battery
NO TICE
charging immediately and dispose of it.
holding the power button. It can be started only after the solar power and AC
power are connected.
Long-term storage will cause capacity loss. After lithium batteries are stored at
the recommended storage temperature for 12 months, the irreversible capacity
loss is 3% to 10%.
Copyright © Huawei Digital Power Technologies Co., Ltd.
7.3 Installing AC Power Cables
7.5 Installing Battery Module Power
7.10 Verifying the Installation
9 System Maintenance
6.3
7.1 Preparing
Cables,
(only AC input
Cables,
Modules.
to verify the
90
Advertisement
Table of Contents
