Table of Contents
Advertisement
Access Point Startup Sequence
Upon power on/start up, the Smart-hopping Access Point performs a Power-on-Self-Test
(POST) to ensure that its basic components are fully functional.
This test detects critical system failures. As the test progresses the state of the system is
displayed through a series of color combinations on the four LEDs on the front of the
Access Point. All four LEDs illuminate Amber color, the Power/Sync LED illuminates green,
the Network and Radio LEDs flash green, and the LED turns off (not illuminated)
indicating correct startup. If a test fails, the LEDs are left in a state which indicates the
point at which the test failed. When the system is transmitting data the radio and
network LEDs on the Access Point flicker on and off as data is transmitted.
Access Point Configuration Information
Refer to the Smart-hopping 2.0 Infrastructure Installation and Service Guide for complete
details about configuring the Smart-hopping Access Point.
Smart-hopping 2.0 Access Point 1.4 GHz Installation Guide
DRAFT - 03 JUN 2022 13:32
Access Point Startup Sequence
2-43
Advertisement
Table of Contents
