Table of Contents
Advertisement
Chapter 2: Mount and Install the Smart-hopping 2.0 Access Point 1.4 GHz
6
7
8
2-34
Remove the Mounting Rail.
With the finished side of the ceiling tile
facing you, use the drill and 1/4-inch
drill bit to drill four holes where you
marked in the BC holes in the previous
steps.
Using the marks you made in Step 5 as
the center point, use a one-inch hole
saw to drill out two one-inch holes in
the ceiling tile. These holes are to pass
cable connectors through the ceiling to
the Access Point.
Lightly coat both plastic grommets
with silicone adhesive and insert them
into both one-inch holes in the tile
(Insert the grommets from the finished
side of the tile).
Put the tile and mounting rail aside.
DRAFT - 03 JUN 2022 13:32
Advertisement
Table of Contents
