Table of Contents
Advertisement
Chapter 2: Mount and Install the Smart-hopping 2.0 Access Point 1.4 GHz
Installation
Caution To mount the Access Point to a wall, connector cables must come through the wall.
1
2-8
Table 2-4: Wall Mounting Tools
Using a 7/32-inch drill bit, drill two
pilot holes 0.219 inches (5.5 mm) in
diameter, 3.394 inches (100 mm) apart
(from the center points of the holes),
and horizontally level with each other.
DRAFT - 03 JUN 2022 13:32
Required Tools
Tape Measure
Level
Hammer (when using wall anchors)
Drill
7/32 -inch drill bit
One-inch hole saw bit
Phillips head screwdriver
T-8 Torx screwdriver
Marker
Silicone Adhesive
Advertisement
Table of Contents
