Table of Contents
Advertisement
Available languages
Available languages
The function CUFF PLACKET TIME allows you to set
the time for pressing the cuffs placket.
.
The factory settings provide for a time of 15
seconds. At the end of the finishing cycle the
clamps still open.
Press the keys +/- of the function to be set up to reach
the required digit.
EXCLUSION
Exclusion, from finishing cycle, for these functions are
available: shoulder press
, bust stretching
.
From "Home" MENU press the related key to
allow/exclude the function; the red square means the
function is OFF
Control icons:
"1 Pedal"
"2 Pedal"
"3 Left clamp"
"4 Right clamp"
"5 Start"
, cuff placket
, short sleeve
Cycle phase icon (For example for short cycle):
AIR
Use
finishing cycle) the ventilation time.
Press the
icon appears; the flashing icon of the arrow and the
flashing icon of the fan running, indicate this function is
active and will continue until stopped; press again the
STEAM
Use this function DURING the finishing cycle, when the
garment needs to be steamed.
Press the
the time needed, this function stops when the key is
released; when the steam icon is on it indicates this
function is active
HEIGHT OF THE SLEEVE TENSIONERS
Use this function
tensioners.
- 10 -
this
function
to
key to activate this function, the
key to disable this function.
key to activate this function and hold for
to adjust the height of the
extend
(during
the
sleeve
Advertisement
Table of Contents
