Siemens LMV5 Quick Start Manual page 17
Hide thumbs
Also See for LMV5:
- Technical instructions (374 pages) ,
- Basic documentation (278 pages) ,
- Manual (39 pages)
Advertisement
Section 2 Mounting
LMV5 Base Unit 2-1
The base unit should be mounted inside an enclosure that will protect the LMV5 from dirt and
moisture. The unit is mounted by four screws that are captive in each corner, and have an M5
thread. The mounting plate that the unit sits on should be drilled and tapped to accommodate these
screws. It should be noted that the mounting screws do not have excessive play, so the spacing of
the mounting holes must be accurate. This can be easily achieved by placing the LMV5 in the
desired position and turning each of the mounting screws to mark the plate that the LMV5 will be
mounted to.
During the mounting process, consideration should also be given to the various plugs and wires that
must be attached to the LMV5. Electrical connections are made via plugs that are located in the
face, top and bottom of the unit. A space of at least two inches is recommended on the top of an
LMV51, and the top and bottom of an LMV52.
Please see Section 10 for specifications.
Figure 2-1.1 LMV5 Base Unit Dimensions (inches)
LMV5 QSG Rev 4
Sec 2
Pg 1
www.scccombustion.com
Advertisement
