Siemens LMV5 Quick Start Manual page 10
Hide thumbs
Also See for LMV5:
- Technical instructions (374 pages) ,
- Basic documentation (278 pages) ,
- Manual (39 pages)
Advertisement
General Accessories
AGG5.210
120 VAC to (3) 12VAC transformer
At least one is required on each BMS
Additional transformers may be necessary
depending on the number of actuator / modules
FUSE6.3A-SLOW
6.3A 250V 5x20mm Slo-Blow Qty (10) LMV5 primary
FUSE4.0A-SLOW
4.0A 250V 5x20mm Slo-Blow Qty (10) LMV5 secondary
AGG5.643
Special cable for use with the CANbus connections
between the LMV5, actuators, and PLL52 module
Supplied in a 500' roll
AGG5.643(100)
Supplied in a 100' roll
AGG5.635
A pre-made cable approximately 9 FT
for connecting the AZL to the LMV5
(AGG5.110 CANbus strain relief included)
AGG5.110
CANbus strain relief
If AZL cable AGG5.635 is used only one is required
P454-006
ACS450 Software cable, PC to AZL, 9 pin D M-F, null Modem
AGG5.720
Base
plug
kit
AGG5.721
Extension
Plug kit
1840382(5)
Replacement green 4 pin connector
1840395(5)
Replacement green 5 pin connector
7466200470
Cord grip, Adapter Nylon, M16 - CANbus cable
7466201040
Conduit adapter, Nylon, M16 - 1/2" NPSM
ADP-M16xE500(5)
Conduit adapter, Metal, M16 - 1/2" NPSM
Note : Typical requirements are (2) M16 per (SQM4) Actuator, (6) M16 per O2 (PLL52)
LMV5 QSG Rev 4
Sec 1
Pg 6
Qty 5
Qty 5
Qty 1
Qty 5
www.scccombustion.com
Qty 1
Advertisement
