Lenovo RackSwitch G8264 Installation Manual page 73
Hide thumbs
Also See for RackSwitch G8264:
- Command reference manual (794 pages) ,
- Application manual (718 pages) ,
- Installation manual (86 pages)
Table of Contents
Advertisement
3.Set the new switch to use the Machine Type‐Model (MTM) number of the old unit. For example:
4.Set the new switch to use the serial number of the old unit. For example:
5.Reset the switch using the following command:
6.When prompted for confirmation, enter y. The switch will then reboot.
7.After the switch reboots, return to the command prompt and verify that the VPD information is correct
using the following command:
© Copyright Lenovo 2017
G8264 (config)# boot mtm 123456X
New MTM value: 123456X
Please reset the system for the new changes to take effect
G8264(config)#
where 123456X is the MTM from your old unit.
Note: The MTM shown here is merely an example—use the actual MTM
recorded from your old G8264 unit.
G8264 (config)# boot esn 1000001
where 1000001 is the serial number of your old unit.
Note: The serial number shown here is merely an example—use the actual
serial number recorded from your old G8264 unit.
G8264 (config)# reload
G8264> show sysinfo
System Information at 0:11:46 Wed Jan 6, 2015
Time zone: America/US/Pacific
Daylight Savings Time Status: Disabled
Lenovo RackSwitch G8264
Switch has been up for 0 days, 0 hours, 10 minutes and 45 seconds.
Last boot: 0:11:36 Wed Jan 6, 2015 (reset from console)
MAC address: fc:cf:62:9d:2b:00 IP (If 1) address: 192.168.49.50
Management Port MAC Address: fc:cf:62:9d:2b:fe
Management Port IP Address (if 4): 192.168.50.50
Hardware Part No: 00D9853
Switch Serial No: Y030PZ23H00E
Manufacturing date:12/12
MTM Value: 123456X
ESN: 1000001
...
For more information about using the switch interface, see the Application Guide and
Command Reference for your switch model and firmware version.
Chapter 4: Removing and Replacing G8264 Components
73
Advertisement
Table of Contents
