Removing The Device - Siemens SIMATIC HMI Unified Comfort MTP700 Operating Instructions Manual

Hide thumbs Also See for SIMATIC HMI Unified Comfort MTP700:

Table of Contents

Mounting and connecting the device

3.5 Removing the device

The following figure shows an example of how to secure a connector in a captive manner.

3.5

Removing the device

The HMI device is generally removed in the reverse order used for installing and connecting.

Procedure

Proceed as follows:

1. If a project is running on the HMI device, close the project with the HMI device configured

for this purpose. Wait until the Control Panel is displayed.

2. Switch off power to the HMI device.

3. When you use the HMI device in a hazardous area, make sure that one of the two

following requirements is met: The area is no longer hazardous or the device and its plug-

in connections are de-energized.

4. Remove all cable ties on the HMI device used for strain relief.

5. Remove all plug-in connectors and the equipotential bonding cable from the HMI device.

6. Secure the HMI device so that it cannot fall out of the mounting cutout.

7. Loosen the screws of the mounting clips and remove all mounting clips.

8. Take the HMI device out of the mounting cutout.

Table of Contents