Table of Contents
Advertisement
2288H V5 Server
User Guide
Bind the new network cable in the same way as the existing network cables. You can also
remove all cable ties and bind all of the network cables again if necessary.
----End
4.5.4 Connecting a Cable to a 10GE Optical Port
You can connect an optical or SFP+ cable to a 10GE optical port. You need to determine the
type of cable to be connected based on site requirements.
Step 1 Wear an ESD wrist strap. For details, see
Step 2 Check the model of the new network cable.
Step 3 Number the new cable.
l
l
Step 4 Lay out the new cable in the same way as the old one.
l
l
l
l
Step 5 Connect the cable to a 10GE port.
When you use an optical cable:
1.
2.
Issue 04 (2018-09-04)
The new cable must have the same number as the old one.
Use the same type of labels for optical cables. Record the name and number of the local
device to be connected on one side of a label and those of the peer device on the other
side. Attach a label 2 cm (0.79 in.) away from the end of a network cable.
Lay out optical cables or SFP+ cables in the rack based on installation regulations. You
are advised to arrange cables in original mode. Ensure that cables are routed neatly and
intact.
Separate optical cables or SFP+ cables from power cables and signal cables when laying
out the cables.
Bend an optical cable or SFP+ cable with a bending radius of at least 4 cm (1.57 in.) to
prevent damage to core wires. Ensure that the cable is intact. Ensure that optical cables
or SFP+ cables are laid out for easy maintenance and capacity expansion.
Bind optical cables with cable ties. Ensure that optical cables are routed straightly and
bound neatly and that cable ties are installed at even spacing and fastened properly.
Remove the old optical cable from the server.
Connect the new optical cable.
NOTE
–
Connect the new optical cable to the same port as the old one.
–
Connect the optical cables to the optical module securely.
a.
Insert the optical module into the optical port. See (1) in
b.
Close the latch on the optical module to secure it. See (2) in
c.
Insert the optical cable into the optical module. See (3) in
Copyright © Huawei Technologies Co., Ltd.
12 Preventing Electrostatic
4 Setup
Discharge.
Figure
4-16.
Figure
4-16.
Figure
4-16.
83
Advertisement
Chapters
Table of Contents
