Siemens SINUMERIK 840Di sl Function Manual page 137
Eps network services
Hide thumbs
Also See for SINUMERIK 840Di sl:
- Commissioning manual (632 pages) ,
- Programming manual (560 pages) ,
- Operating manual (470 pages)
Table of Contents
Advertisement
12/2008
Fig. 3-38: Selecting a maintenance schedule for control monitor
Field
Create maintenance
schedule
Open maintenance
schedule
Paper clip
Delete maintenance
schedule
© Siemens AG 2008 All Rights Reserved
ePS Network Services, Function Manual (FH) - Release 12/2008
Content
From here, it is possible to switch directly to
the creation of a new maintenance schedule.
Open and edit an existing maintenance
schedule
Note:
Changes to the maintenance schedule only
affect new jobs. Jobs that are already open
and are, therefore, already being carried out,
as well as jobs that are closed, remain
documented in their original state.
Notice:
Renaming a maintenance schedule results in
automatic reprogramming of all control
monitors in the background where the
schedule is configured. Consequently, it is not
possible to create all of the required control
monitors successively on the basis of a single
plan.
Use the maintenance schedule displayed in
this line as a job, if the control monitor has
been triggered. Any of the maintenance
schedules can be selected. Those that have
been selected are shown in yellow.
Deletes a maintenance schedule
Note:
Deletion is only possible if the schedule that is
to be deleted is not used in any other control
monitors, or controlled independently.
However, if a maintenance schedule that
creates a job in a control monitor is missing,
this is documented and displayed in an entry in
the event history.
If the schedule becomes available again (i.e. a
new version is created), it will also be created
in the right format to act as a job.
3 Setting up functions
3.4 Fault services
Type
ACTION
ACTION
ACTION
ACTION
3-137
Advertisement
Table of Contents
