Siemens Sinumerik 840D Series Function Manual page 205
Hla module
Hide thumbs
Also See for Sinumerik 840D Series:
- Function manual (920 pages) ,
- Diagnostics manual (714 pages) ,
- Operating turning (713 pages)
Table of Contents
Advertisement
02.99
10.03
Response
Remedy
Continue program
310 709
Explanation
Response
Remedy
Continue program
Siemens AG, 2003. All rights reserved
SINUMERIK 840D/SIMODRIVE 611 digital, HLA Module (FBHLA) - 10.03 Edition
NC not ready.
Channel not ready.
NC stopped in response to alarm.
NC start disable.
The NC switches to follow-up mode.
Alarm display.
Interface signals are set.
Match the number of encoder marks for the motor measuring system set in MD
5005: ENC_RESOL_MOTOR (no. of encoder marks motor measuring system)
to the bar number of the connected encoder. (Default setting for motor measur-
ing system: (Default setting for motor measuring system: 2048 incr./rev.).
Switch control system OFF and ON again.
Axis %1, drive %2 error in piston diameter or piston rod diameter
%1 = NC axis number
%2 = drive number
The piston diameter in drive MD 5131: CYLINDER_PISTON_DIAMETER is less
than zero
Or
the piston rod diameter set in drive MD 5132:
CYLINDER_PISTON_ROD_A_DIAMETER is greater than the piston diameter
set in drive MD 5131: CYLINDER_PISTON_DIAMETER
Or
the piston rod diameter set in drive MD 5133:
CYLINDER_PISTON_ROD_B_DIAMETER is greater than the piston diameter
set in drive MD 5131: CYLINDER_PISTON_DIAMETER
NC not ready.
Channel not ready.
NC stopped in response to alarm.
NC start disable.
The NC switches to follow-up mode.
Alarm display.
Interface signals are set.
Enter a valid piston diameter setting in drive MD 5131:
Enter CYLINDER_PISTON_DIAMETER (0 t D v 500 mm).
Or
set the piston rod diameter in drive MD 5132:
CYLINDER_PISTON_ROD_A_DIAMETER to a lower value than the piston di-
ameter in drive MD 5131: CYLINDER_PISTON_DIAMETER.
Or
set the piston rod diameter in drive MD 5133:
CYLINDER_PISTON_ROD_B_DIAMETER to a lower value than the piston di-
ameter in drive MD 5131: CYLINDER_PISTON_DIAMETER.
Switch control system OFF and ON again.
6 Hydraulics Diagnostics
6-205
- Quick Links:
- Typical Applications
- General
- Drive Configuration
Hide quick links:
Advertisement
Table of Contents
