Table of Contents
Advertisement
1. Garnish
2. Screws
3. Door mirror
MIRROR CONNECTOR (Both side)
INSPECTION
Mirror Switch
1) Take out mirror switch from instrument panel.
2) Check continuity at each switch position by using a circuit tester.
If any continuity is not obtained, replace mirror switch.
RH
1
1
LH
UP
DOWN
LEFT
RIGHT
Door Mirror
1) Remove garnish and screws from door.
2) Remove door mirror from door by disconnecting coupler.
3) Check that door mirror operates properly when battery voltage
is applied to connector terminals.
If faulty is found, correct or replace.
NOTE:
When installing door mirror to door, be careful not to pinch
harness between door and door mirror.
BODY ELECTRICAL SYSTEM 8-59
6
2
2
3
3
7
5
4
- Quick Links:
- How to Use this Manual
- Wiring Diagram
Hide quick links:
Advertisement
Chapters
Table of Contents
