Table of Contents
Advertisement
53) Install 2nd and 4th brake band.
54) Install 1st and reverse clutch while rotating counterclockwise
1. 2nd and 4th brake band
2. 1st and reverse clutch
55) Check for correct installation of input shaft as follows.
1. Vernier
2. Straightedge
3. Input shaft
56) Tighten manual detent spring with bolts.
1. Manual detent spring
57) Install oil strainer.
1. Oil strainer
2. Oil reservoir plate
58) Tighten oil reservoir plate with bolts.
and clockwise.
Measure the distance "a" by using vernier and straightedge. If
out of specification, remove input shaft with 1st and reverse
clutch and reinstall them properly.
Distance "a": 85.65 – 86.39 mm (3.372 – 3.401 in.)
Tightening Torque
(a): 10 N·m (1.0 kg-m, 7.5 Ib-ft)
NOTE:
It is recommended to set to neutral position between
spring detent and lever manual valve and then tighten
bolts (1).
Tightening Torque
(a): 5.5 N·m (0.55 kg-m, 4.0 lb-ft)
AUTOMATIC TRANSMISSION 7B1-151
- Quick Links:
- How to Use this Manual
- Wiring Diagram
Hide quick links:
Advertisement
Chapters
Table of Contents
