Table of Contents
Advertisement
7B1-102 AUTOMATIC TRANSMISSION
1. Forward clutch drum assembly
2. Transmission rear cover
DISASSEMBLY
1) Remove flange, discs and plates by removing snap ring in the
following order.
<G16 engine model>
(1) Flange " (2) Disc " (3) Plate " (4) Disc " (5) Plate
<J18 engine model>
(1) Flange " (2) Disc " (3) Plate " (4) Disc " (5) Plate
" (6) Disc " (7) Plate
1. Snap ring
2) Remove clutch drum thrust washer.
3) Using special tool and hydraulic press, compress forward
clutch return spring subassembly and remove snap ring.
Special Tool
(A): 09926-98330
CAUTION:
Be careful when applying pressure, for overpressure
will cause plate section of forward clutch return
spring subassembly to deform.
1. Snap ring
2. Press
4) Remove forward clutch return spring subassembly.
5) Install forward clutch piston subassembly to transmission rear
cover.
6) Remove forward clutch piston subassembly with O-rings
installed through oil hole "A" compressed air (400 – 800 kPa,
4 – 8 kg/cm
NOTE:
D If piston does not pop out, it is recommended to use
needle-nose pliers for removal.
D Never reuse removed O-rings.
7) Remove clutch drum oil seal rings of forward clutch drum sub-
assembly and transmission rear cover.
3. Oil seal ring
4. Oil seal ring
2
, 57 – 113 psi).
- Quick Links:
- How to Use this Manual
- Wiring Diagram
Hide quick links:
Advertisement
Chapters
Table of Contents
