05.07
10.3 Defining the station name and type
Fig. 10-1: Settings
General
The Tools Settings function can be used to configure the station name and
type once after DNC Plant has been installed. This can only be done in
configuration mode. This does not need to be carried out for DNC Cell. The two
fields are deactivated.
Station name
If the computer to be configured is the DNC server or a station PC, specify the
name of the station for your computer here. If the computer to be configured is a
terminal server client, the station name is assigned automatically if the Terminal
Server Client checkbox is activated. In this case, the station name is the name of
the terminal server client.
Note
If the computer to be configured is a terminal server client and the Terminal
Server Client checkbox is not activated, overwrite the station name of the server.
© Siemens AG 2010 All Rights Reserved
Motion Control Information System DNC (FBDN) - 04/10 Edition
DNC Plant/DNC Cell (FBDN1)
10 Configuration
FBDN1/10-159