61501
[Channel %1: ] Block %2: Simulation is active
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
The alarm can be triggered by the following grinding cycles: all grinding cycles
Remedy:
Reset simulation
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61502
[Channel %1: ] Block %2: No tool offset active
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
The alarm can be triggered by the following grinding cycles: all grinding cycles
Remedy:
A tool number must be programmed
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61503
[Channel %1: ] Block %2: tool nose radius compensation left or right
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
The alarm can be triggered by the following grinding cycles: CYCLE410, CYCLE411, CYCLE412, CYCLE413,
CYCLE414, CYCLE415, CYCLE416, CYCLE420
Remedy:
A tool offset value has to be programmed
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61504
[Channel %1: ] Block %2: _KNG incorrect for setup
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
The alarm can be triggered by the following grinding cycle: setup function
Remedy:
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61505
[Channel %1: ] Block %2: retraction path < 1mm
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
The alarm can be triggered by the following grinding cycle: CYCLE420
Remedy:
Increase retraction path
Program
Clear alarm with the RESET key. Restart part program
Continuation:
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
453