Write Online Tool Offset Discretely; Information About Online Offsets - Siemens SINUMERIK Series Function Manual

Extended functions

Hide thumbs Also See for SINUMERIK Series:

Table of Contents

Write online tool offset discretely

This command writes an offset value by means of a program command.

PUTFTOC(<value>, <length1_2_3>, <channel no.>, <spindle no.>)

Put Fine Tool Offset Compensation

The wear of the specified length (1, 2 or 3) is modified online by the programmed value.

The online tool offset for a (geometric) grinding tool that is not active can be activated by

specifying the appropriate spindle number.

If the channel number is omitted, the online offset is effective in the same channel.

If the spindle number is omitted, the online offset is applied to the current tool.

Response in the case of tool change

● In cases where

● Cutting edge changes can be implemented without preprocessing stop.

Machining plane and transformation

● It is not possible to change transformations or planes (e.g.

Extended Functions

Function Manual, 03/2013, 6FC5397-1BP40-3BA1

preprocessing stop with resynchronization is initiated in the control when a tool is

Tool changes can be executed in conjunction with the online tool offset through the

selection of T numbers.

Tool changes with

cannot be executed in conjunction with the online tool offset

can be used only in conjunction with the "Inclined axis" transformation.

active, except in the

W4: Grinding-specific tool offset and tool monitoring

has been active since the last tool or cutting edge change,

17.2 Online tool offset

Show Quick Links

Table of Contents

Sinumerik 840d sl Sinumerik 828d