Configuration - Siemens SINUMERIK Series Function Manual
Extended functions
Hide thumbs
Also See for SINUMERIK Series:
- Operating manual (940 pages) ,
- Function manual (332 pages) ,
- Function manual (204 pages)
Table of Contents
Advertisement
S3: Synchronous spindle
13.3 Configuration
13.3
Configuration
Note
One synchronous-spindle coupling can be configured for each channel.
Table 13- 1
Machine data
Number
Name: $MC_
MD21300
COUPLE_AXIS_1[<n>]
MD21320
COUPLE_BLOCK_
CHANGE_CTRL_1
MD21310
COUPLING_MODE_1
MD21330
COUPLE_RESET_
MODE_1
MD21340
COUPLE_IS_WRITE_
PROT_1
1) See MD21340 $MC_COUPLE_IS_WRITE_PROT_1
Table 13- 2
Setting data
Number
Name: $SC_
SD42300
COUPLE_RATIO_1[<n>]
1) See MD21340 $MC_COUPLE_IS_WRITE_PROT_1
728
Function
Machine axes of the synchronous-spindle coupling:
<n> = 0: Machine axis number of the following spindle
•
<n> = 1: Machine axis number of the leading spindle
•
Machine axis numbers in accordance with: MD20070
$MC_AXCONF_MACHAX_USED (machine axes in the channel)
Machine axis numbers == 0: No coupling configured. The following system data
is then not relevant.
Note: The machine axes configured for the synchronous-spindle coupling cannot
be changed using program commands.
Block change release after activating the synchronous operation
Immediately
•
On reaching "Synchronism fine"
•
On reaching "Synchronism coarse"
•
On reaching "Synchronism setpoint"
•
Note: No change protection
command.
COUPDEF
Coupling type
:
1)
Actual value coupling
•
Setpoint value coupling
•
Speed coupling
•
Note: No change protection
coupling with the
COUPDEF
Behavior of the synchronous-spindle coupling with regard to NC Start, NC Stop
and Reset.
Change protection for coupling
Function
Speed transmission ratio: FS / LS = numerator / denominator
<n> = 0: Numerator (FS)
•
<n> = 1: Denominator (LS)
•
Note: No change protection
command.
COUPDEF
, the block change release can be changed with the
1)
, the coupling type can be changed for deactivated
1)
command.
, the transmission ratio can be changed with the
1)
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
:
1)
:
1)
Extended Functions
- Quick Links:
- Access Via Plc
Hide quick links:
Advertisement
Table of Contents
