Mounting The Charging Station; Setting Transponder Id And Inserting The Battery - Siemens SIMATIC HMI Operating Instructions Manual
Hmi device
mobile panel 277f iwlan
Hide thumbs
Also See for SIMATIC HMI:
- Operating instructions manual (121 pages) ,
- Start-up instructions (40 pages) ,
- Product information (25 pages)
Table of Contents
Advertisement
Installation and connection
4.2 Mounting the charging station
4.2
Mounting the charging station
Requirements
● 4 x M6 cylinder head screws, with nuts if required
● You have selected a location with a low ambient temperature
● You have selected a position for the charging station that is easy and safe to reach
● You have selected a good ergonomic height for the charging station
Procedure
Proceed as follows:
1. Place the charging station from the front onto the mounting surface.
2. Mark the fastening holes with a marking-off tool.
3. Drill 4 through holes or 4 x M6 threaded holes.
4. Mount the charging station.
Result
The charging station is now mounted.
See also
Mounting location and clearance of charging station (Page 54)
Application and ambient conditions (Page 51)
4.3
Setting transponder ID and inserting the battery
Introduction
To operate the transponder you must first insert the batteries and set the transponder ID.
The transponder ID is read and evaluated by the HMI device in the current project.
Requirements
● Torx screwdriver, size T10
● Screwdriver, size 0
● 3 AA mignon batteries, 1.5 V, included in delivery
66
To charge the batteries, the ambient temperature / battery temperature must not exceed
40 °C
Mobile Panel 277F IWLAN
Operating Instructions, 12/2007, A5E01003940-01
Hide quick links:
Advertisement
Table of Contents
