Table of Contents
Advertisement
ANNEX D.
D.1 Cleaning Optic Connector
When connecting optical cable to the system, performance of system can be decreased or
fails can occur if core section of optical connector is dirty due to dust or foreign material.
Therefore, worker should clean the optic connector before connecting optic cable to the
system to prevent this phenomenon.
This manual describes the method that cleans optic connector when using the IBC
cleaner.
Caution When Connecting the Optical Cable
When connecting the optical cable, be careful to keep the cutting section of the
connector core away from dust or foreign material.
If the cable is soiled with foreign material, do not blow to remove them. Make sure
to clean the connector in accordance with the cleaning directions below.
When using Optic Connector Cleaner
When using optic connector cleaner, use the products shown in the example
below or their equivalents.
Ex) Manufacturer-USCONEC (http://www.usconec.com)
© SAMSUNG Electronics Co., Ltd.
Cleaning Optic Connector
TM
- IBC
Brand Cleaner (P/N: 9393): For LC-LC and MU Connector Cleaning
TM
- IBC
Brand Cleaner (P/N: 9392): For SC Connector Cleaning
TM
- IBC
Brand Cleaner (P/N: 12910): For ODC Connector Cleaning
Manufacturer-TheFibers (www.thefibers.com)
- HuxCleaner 1.25 mm (0.05 in.)Type: For LC and MU Connector Cleaning
- HuxCleaner 2.5 mm (0.10 in.) Type: For SC, FC and ST Connector Cleaning
Mobile WiMAX/TD-LTE RRH-2WB Installation Manual
TM
Brand
D-1
Advertisement
Table of Contents
