Installation On A Standard S7-300 Rail - Siemens SIMATIC NET Operating Instructions Manual
Network components
Hide thumbs
Also See for SIMATIC NET:
- Configuration manual (464 pages) ,
- System manual (372 pages) ,
- Manual (300 pages)
Table of Contents
Advertisement
4.4
Installation on a standard S7-300 rail
Installing on an S7-300 standard rail
Figure 4-2
To install the device on an S7-300 standard rail, follow the steps below:
1. Place the second housing guide of the device on the top edge of the standard rail.
2. Screw the device to the lower part of the standard rail with the supplied screw.
3. Fit the connectors for the power supply, see the section "Power supply (Page 39)".
4. Fit the connectors for the signaling contact, see the section "Signaling contact (Page 40)".
5. Fit the connectors for the digital input, see the section "Digital input (Page 41)".
6. Insert the terminal blocks into the sockets on the device.
Removal
To remove the device from a standard rail, follow the steps below:
1. Disconnect all connected cables.
2. Release the screw on the bottom of the standard rail.
3. Remove the device from the standard rail.
SCALANCE XC100-4OBR
Operating Instructions, 10/2013, C79000-G8976-C297-02
S7-300 standard rail mounting
4.4 Installation on a standard S7-300 rail
Mounting
35
Advertisement
Table of Contents
