HP 10500 Series Configuration Manual page 66
Hide thumbs
Also See for 10500 Series:
- Security configuration manual (596 pages) ,
- Configuration manual (512 pages) ,
- Specifications (42 pages)
Table of Contents
Advertisement
Step
3.
Enable password
authentication.
4.
Set a password.
5.
(Optional.) Assign a
user role.
The next time you Telnet to the device, you must provide the configured login password, as shown
in
Figure
13.
Figure 13 Password authentication interface for Telnet login
Configuring scheme authentication for Telnet login
Step
1.
Enter system view.
Command
authentication-mode password
set authentication password { hash |
simple } password
user-role role-name
Command
system-view
56
Remarks
By default, password authentication is
enabled for VTY lines.
In VTY line view, this command is
associated with the protocol inbound
command. If you specify a non-default
value for only one of the two commands
in VTY line view, the other command
uses the default setting, regardless of
the setting in VTY line class view.
By default, no password is set.
By default, a VTY line user of the default
MDC is assigned the user role
network-operator. A VTY line user of a
non-default MDC is assigned the user
role mdc-operator.
Remarks
N/A
Advertisement
Table of Contents
Troubleshooting
