Snow Removal Assist/Rapid Defrost Function; Rapid Defrost - LG Multi V5 Service Manual
Hide thumbs
Also See for Multi V5:
- Data manual (162 pages) ,
- Manual book (133 pages) ,
- Engineering manual (105 pages)
Table of Contents
Advertisement
OTHER CONTROLS
Setting Optional Modes
Function (Fn6)
Snow Removal Assist
Snow Removal Assist function allows the outdoor unit(s) fans to
operate at regular intervals, for two (2) minutes, at specified speeds
(as seen in the tables below) to remove snow accumulation from the
fan discharge.
The function will only operate when the system has not called for
compressor activity (no demand for heating or cooling) for thirty (30)
minutes, and when the outdoor air temperature is <37ºF. Operates
every thirty (30) minutes for two (2) minutes. Function will stop if
there is an operation error code, or if a compressor starts. Use this
function in areas where snow accumulating on the fan blades and
fan guard is common.
Rapid Defrost
Rapid Defrost function limits the amount of frost and ice are allowed
to build on the coil between defrost cycles (defrost cycles occur
more often). System pressure is monitored, and when system pres-
sure is reduced, the defrost cycle is initiated.
Snow Removal Assist / Rapid Defrost can also be used with Fn4
- Overall Defrost, and Fn22 - Overall Defrost Operating in Low
Temperatures (Heating).
Snow Removal Assist and Rapid Defrost can be used on both heat
pump and heat recovery systems.
Table 27: Setting the Snow Removal / Rapid Defrost Function.
Settings
oFF (Default)
op1
op2
op3
Snow Removal Assist Mode and Rapid Defrost Mode
68
Details
Mode Is Not Set
Snow Removal Assist Mode
Rapid Defrost Mode
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
Figure 16: Setting the Snow Removal / Rapid Defrost Function.
Turn No. 5 on the master outdoor unit PCB
DIP switch bank SW01 to ON.
Select from "oFF," "op1" through "op3" options (see table) by using the
The Snow Removal / Rapid Defrost function is set.
PCB does not need reset.
• A trained LG service provider must set this function during system
installation.
• If the snow removal / rapid defrost mode is not used, set to OFF.
Fan Speed During Snow Removal Assist (RPM)
6 Ton
-
670
-
670
8 to 20 Ton
-
850
-
850
Advertisement
Table of Contents
Troubleshooting
