Simultaneous Recording During Machining Of The Workpiece - Siemens SINUMERIK 828D Operating Manual
Hmi sl milling
Hide thumbs
Also See for SINUMERIK 828D:
- Function manual (1799 pages) ,
- Commissioning manual (1167 pages) ,
- Operating manual (926 pages)
Table of Contents
Advertisement
5.4
Simultaneous recording during machining of the workpiece
If the view of the work space is blocked by coolant, for example, while the workpiece is being
machined, you can also track the program execution on the screen.
Procedure
Note
• If you switch-on simultaneous recording after the unmachined part information has
• If you switch-off simultaneous recording during machining and then switch-on the function
HMI sl Milling
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
Software option
You require the option "Simultaneous recording (real-time simulation)" for
the simultaneous recording.
1.
Load a program in the "AUTO" mode.
2.
Press the "Sim. rec." softkey.
3.
Press the <CYCLE START> key.
The machining of the workpiece is started and graphically displayed
on the screen.
4.
Press the "Sim. rec." softkey again to stop the recording.
already been processed in the program, only traversing paths and tool are displayed.
again at a later time, then the traversing paths generated in the intermediate time will not
be displayed.
5.4 Simultaneous recording during machining of the workpiece
Simulating machining
159
Advertisement
Table of Contents
