4.7.6
Parameters for block search in the search pointer
Parameter
Number of program level
Program:
Ext:
P:
Line:
Type
Search target
4.7.7
Block search mode
Set the desired search variant in the "Search Mode" window.
The set mode is retained when the the controller is shut down. When you activate the
"Search" function after restarting the controller, the current search mode is displayed in the
title row.
Search variants
Block search mode
With calculation
- without approach
With calculation
- with approach
HMI sl Milling
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
Meaning
The name of the main program is automatically entered
File extension
Pass counter
If a program section is performed several times, you can enter the number of
the pass here at which processing is to be continued
Is automatically filled for an interruption point
" " search target is ignored on this level
N no. Block number
Label Jump label
Text string
Subprg. Subprogram call
Line Line number
Point in the program at which machining is to start
Meaning
It is used in order to be able to approach a target position in any
circumstance (e.g. tool change position).
The end position of the target block or the next programmed position is
approached using the type of interpolation valid in the target block. Only the
axes programmed in the target block are moved.
It is used to be able to approach the contour in any circumstance.
The end position of the block prior to the target block is found with <CYCLE
START>. The program runs in the same way as in normal program
processing.
Machining the workpiece
4.7 Starting machining at a specific point
135