Replacing The Expansion Cabinet Rx Splitter; Figure 162: Schematic Diagram Of Rx Splitter - Motorola DIMETRA MTS 4 Installation, Configuration, And Service Manual
Dimetra ip scalable (dips); dimetra ip compact (dipc)/scalable dimetra ip (sdip); dimetra ip micro/dimetra ip lite
Hide thumbs
Also See for DIMETRA MTS 4:
Table of Contents
Advertisement
Applicant: Motorola Solutions
Figure 162: Schematic Diagram of RX Splitter
Replacing the Expansion Cabinet RX Splitter
This process outlines the recommended tasks to be performed to replace the Expansion Cabinet RX Splitter. For a list
of available FRUs, see
Process:
1 Remove the RX splitter, see
2 Reinstall the RX splitter, see
Removing the RX Splitter
This procedure describes how to remove the RX Splitter.
Procedure:
1 Remove the door of the cabinet completely.
2 Remove the four screws holding the front panel.
3 Loosen the two screws holding the front section of the top panel and slide off the panel.
4 Loosen the screws fastening the rear section of the top panel and slide off the panel.
5 Remove the RX cables connected to the back of the RX Splitter.
6 Loosen the two fastening screws at the front enough to free the mounting bracket.
7 Slide the RX Splitter out of the cabinet.
8 Remove the RX Splitter from the bracket and replace with the new unit.
Reinstalling the RX Splitter
This procedure describes how to reinstall the RX Splitter.
Procedure:
1 Fasten the RX Splitter onto the bracket.
2 Slide the RX Splitter into the cabinet.
3 Tighten the two fastening screws at the front.
4 Connect the RX cables to the back of the RX Splitter.
5 Slide on the top rear and front panels and fasten these with screws.
Field Replaceable Units (FRUs) on page
Removing the RX Splitter on page
Reinstalling the RX Splitter on page
Equipment Type: ABZ89FC5827 / 109AB-5827
Radio Frequency Distribution System | 261
405.
261.
261.
6802800U74-AD | September 2014 |
Send Feedback
Exhibit D2
- Quick Links:
- Mts 4 Components
Hide quick links:
Advertisement
Chapters
Table of Contents
