Configuration And Parameter Assignment - Siemens SIMATIC Operating Instructions Manual

Distributed i/o fail-safe engineering et 200pro distributed i/o system - fail-safe modules
Hide thumbs Also See for SIMATIC:
Table of Contents

Advertisement

Example for PROFIBUS DP
In the following example, modules with a total parameter length of 205 bytes were used in an
ET 200pro. There are also 39 bytes available for installation of additional modules.
Number and
type of
modules
Parameter
length
ET 200pro: Limitation and Maximum Configuration
For information on the limitations and maximum configuration of the standard ET 200pro,
refer to the
2.4

Configuration and Parameter Assignment

Requirements
The following are required for configuring and assigning parameters for ET 200pro fail-safe
modules:
The
http://www.siemens.com/automation/service&support
Configuring
Fail-safe modules are configured in the same way as ET 200pro standard modules with
STEP 7 HW Config
Assigning Parameters for Electronic Module Properties
To assign parameters to fail-safe electronic module properties, select the module in
HW Config
During a download operation, the parameters are transferred from the programming device
(PG) to the F-CPU and stored there. The parameters are then transferred from the F-CPU to
the fail-safe module.
ET 200pro Distributed I/O System - Fail-Safe Modules
Operating Instructions, 05/2007, A5E00394073-02
: 1 x
IM154-2
HIGH
FEATURE
: 27 bytes
ET 200pro Distributed I/O System
STEP 7
, V 5.3 SP2 or higher; HSP 63 to 68
S7 Distributed Safety
, V 5.1 or higher
F Configuration Pack
, V 5.5 SP2 or higher
F Configuration Pack
.
and select "Edit > Object Properties".
2.4 Configuration and Parameter Assignment
+
2 x
+
8/16 F-
DI
+
84 bytes +
manual.
V 5.5 SP2 is available for download on the Internet at:
2 x
+
1 x
4/8 F-DI/4
F-Switch
F-DO
PROFIsafe
68 bytes
+
26 bytes
Configuration
= 6
modules
= 205 byte
s
STEP 7
21

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents