When
When the transceiver is connected to TeleMon:
Connected
to TeleMon
Turning SpO
Monitoring Off
2
To turn SpO
SpO
transceiver, thereby conserving battery life.
It is important to disconnect the sensor from the transceiver in order to conserve
battery life. Unplugging the sensor from an adapter cable that is connected to
the transceiver does NOT provide SpO
SpO
configured for Continuous SpO
without turning SpO
Silencing this technical alarm will turn the SpO
Draft - 1 Aug 08
•
The SpO
measurement mode is always Continuous.
2
•
You can change the mode. Changes to the mode take effect when the
transceiver is disconnected from TeleMon. The following settings will be
used:
Mode Set at TeleMon
Continuous
5-minute
1-minute
Manual
monitoring off, disconnect the sensor cable from the transceiver.
2
enters a power-down mode after the cable is disconnected from the
2
should also be turned off at the Information Center. If the transceiver is
2
off, a SpO2T NO SENSOR technical alarm will result.
2
Mode when Transceiver
is Disconnected
Continuous
Continuous
Continuous
Spot Check
power-down mode.
2
measurement and the sensor is removed
2
measurement off.
2
Measuring SpO
SpO
Monitoring
8-19
2
2