Samsung DCS Programming Manual page 286
Combined systems
Hide thumbs
Also See for DCS:
- Technical manual (287 pages) ,
- Programming manual (277 pages) ,
- Installation manual (75 pages)
Table of Contents
Advertisement
SAMSUNG
COMBINED SYSTEMS PROGRAMMING MANUAL
MMC: 726
FOR:
Purpose: Sets in-band signalling for voice mail or auto attendant parameters. There are
eight main options for programming and several sub-options to customise the applica-
tion. Simple YES/NO, numeric and alpha characters are required for setting VM/AA.
The following options may be selected for VM/AA operation:
0 EXT FOR DN1
1 TRK FOR DN1
2 EXT FOR DN2
3 TRK FOR DN2
4 SEPARATOR
5 DISCONNECT SIGNAL
6 CALL TYPE ID
DIRECT CALL
0
ALL FWD CALL
1
BSY FWD CALL
2
NOA FWD CALL
3
RECALL
4
DIR TRK CALL
5
OVERFLOW
6
DID CALL
7
MESSAGE CALL
8
VM/AA OPTIONS
ALL SYSTEMS
DTMF information for the station that called the VM/AA
port station which is forwarded to VM/AA port.
DTMF information for the trunk that called the VM/AA
port.
DTMF information for the station that originated the call
to a station which is forwarded to a VM/AA port.
DTMF information for the trunk that called a station for-
warded to a VM/AA port.
In cases where DN2 is used, this specific digit is sent
between the DN1 and the DN2 information. Both DN1
and DN2 must be set to YES for SEPARATOR to be
sent.
This signal is sent when the calling station or C.O. line
hangs up.
Under this VM/AA option are several customising appli-
cations:
A call originating directly from another station in the sys-
tem.
This indicates that a call was forwarded to the VM/AA
port from a station with CALL FORWARD ALL set.
This indicates that a call was forwarded to the VM/AA
port from a station with CALL FORWARD BUSY set.
This indicates that a call was forwarded to the VM/AA
port from a station with CALL FORWARD NO ANSWER
set.
A call is recalling the VM/AA port after being transferred
and not answered.
A C.O. call has gone directly to VM/AA (e.g., trunk 717
DIL to VM/AA).
A call has OVERFLOWED to the VM/AA port from a sta-
tion group.
A DDI call has called the VM/AA port.
A message key or message reply feature code has been
used to call the VM/AA port.
MMC 726 (Page 1 of 3)
MMC PROGRAMS
FEBRUARY 2004
Hide quick links:
Advertisement
Table of Contents
