Samsung DCS Programming Manual page 169
Combined systems
Hide thumbs
Also See for DCS:
- Technical manual (287 pages) ,
- Programming manual (277 pages) ,
- Installation manual (75 pages)
Table of Contents
Advertisement
SAMSUNG
COMBINED SYSTEMS PROGRAMMING MANUAL
MMC: 420
FOR:
DCS
CII
iDCS100
Purpose: Allows the system DDI/NORMAL access and sets dial sending mode
(DLSEND) on an individual port basis to OVERLAP or ENBLOCK. However, if you
change the dial sending mode of one port, all other ports must be set to the same dial
sending mode. Be aware that some of the following options may not be available on
your system.
OPTIONS
CHANNEL ANY: If set to YES, when a call is initiated the channel used is specified by
the network; if set to NO, when a call is initiated the system will specify which channel to
use.
PRI MODE: If your PRI line is not registered for DDI service at the Central Office, you
can use NORMAL service (e.g. subaddress or normal trunk incoming service). If you set
PRI MODE to DDI, you can service DDI (Direct Dial Inward) to a specific station or sta-
tion group according to DDI NUMBER TABLE.
DLSEND: Overlap or Enblock. If Enblock, digits are sent in a single block; if Overlap, dig-
its are sent as they dialled.
CLIP TABLE: Used to select the CLIP number to send to the network. If NONE is se-
lected, the trunk number set in
wise, the number entered in
ber set here is sent to the network.
NB TYPE: Changes the number type field of the set-up message for the CLIP number
sent to the network. Options are UNKNOWN, INT NAT (International), NATIONAL,
NETWORK SUBSCRIB, ABBREV and EXTEN.
NB PLAN: Sets the type of number sent to the network. Options are UNKNOWN, ISDN,
DATA, TELEX, NATION, PRIVATE and EXTEN.
Note: If changes are made using this MMC, the PRI card affected must be restarted using
418, Card Restart.
ACTION
1. Open programming and select 420
Display shows
2. Dial PRI trunk number (e.g. 704)
OR
Press VOLUME keys to select the port
Press the RIGHT soft key to move the cursor
3. Press VOLUME keys to make selection
(CHANNEL ANY, PRI MODE or DLSEND) and
press RIGHT soft key to move the cursor
iDCS500
OS500
MMC 405 (Trunk Number)
MMC 323 (Send CLIP Number)
MMC 420 (Page 1 of 2)
MMC PROGRAMS
FEBRUARY 2004
PRI OPTIONS
is sent to the network. Other-
corresponding to the num-
DISPLAY
[701] PRI OPTION
CHANNEL ANY:YES
[704] PRI OPTION
CHANNEL ANY:YES
[704] PRI OPTION
DLSEND : OVERLAP
MMC
Hide quick links:
Advertisement
Table of Contents
