Table of Contents
Advertisement
Remove and Replace the Ballast
The ballast is located in the chassis above and forward of the power supply. The ballast steps up power
from the power supply to ignite the lamp module.
DANGER
Do not attempt to measure the output voltage from the ballast when the lamp strikes. High
voltage produced by the ballast to strike the lamp can ruin test instruments as well as cause
personal injury.
1.
Remove the following items:
Lamp module (see page 37)
Outer handle (see page 41)
Rear bezel (see page 51)
Top case (see page 57)
Controller ECA (see page 16)
2.
Remove the two M3x6 Torx screws from the lamp connector retainer on the front of the chassis.
TDP-MT8 Service Guide
7
- Quick Links:
- Power and Start-Up Problems
Hide quick links:
Advertisement
Table of Contents
