Table of Contents
Advertisement
Remove and Replace the Leveling Foot
The leveling foot consists of the leveling foot knob and the leveling foot shaft. The leveling foot knob
adjusts the leveling foot and fastens to the leveling foot shaft. The shaft threads to the bottom case from
the inside. When you rotate the knob, the foot and shaft move up and down. You can order either piece
individually.
Remove the leveling foot knob
1.
Place the projector upside down on a soft work surface.
2.
Rotate the leveling foot counterclockwise until it is fully extended.
3.
Remove the rubber foot from the knob. Save the foot for use with the replacement knob.
4.
Remove the M3x8 Plastite Torx screw in the center of the knob.
Remove the leveling foot shaft
1.
Remove the leveling foot knob, then remove the following items:
Top case (see page 57)
Controller ECA (see page 16)
Chassis (see page 13)
TDP-MT8 Service Guide
39
- Quick Links:
- Power and Start-Up Problems
Hide quick links:
Advertisement
Table of Contents
