Displaying And Maintaining Web Login; Web Login Configuration Examples - HP 830 Series Configuration Manual
Poe+ unified wired-wlan switch
Hide thumbs
Also See for 830 Series:
- Configuration manual (530 pages) ,
- Command reference manual (136 pages) ,
- Installation manual (58 pages)
Table of Contents
Advertisement
Step
6.
Associate the HTTPS
service with an ACL.
7.
Create a local user and
enter local user view.
8.
Configure a password for
the local user.
9.
Specify the command
level of the local user.
10.
Specify the Web service
type for the local user.
11.
Exit to system view.
12.
Create a VLAN interface
and enter its view.
13.
Assign an IP address and
subnet mask to the
interface.
Displaying and maintaining Web login
Task
Display information about Web
users.
Display HTTP state information.
Display HTTPS state
information.
Web login configuration examples
The configuration examples were created on the 10500/7500 20G unified wired-WLAN module and
might vary with device models.
When configuring the 10500/7500 20G unified wired-WLAN module, make sure the settings are
correct (including VLAN settings) on the internal Ethernet interface that connects the module to the switch.
For more information, see HP 10500/7500 20G Unified Wired-WLAN Module Fundamentals
Configuration Guide.
By default, the aggregate interfaces between the access controller engine and the switching engine on
an 830 switch are Access interfaces in VLAN 1. When configuring the two aggregate interfaces, make
sure their permitted VLANs are the same. HP also recommends setting their link type to be the same.
Command
ip https acl acl-number
local-user user-name
password { cipher | simple }
password
authorization-attribute level level
service-type web
quit
interface vlan-interface
vlan-interface-id
ip address ip-address { mask |
mask-length }
Command
display web users [ | { begin | exclude |
include } regular-expression ]
display ip http [ | { begin | exclude |
include } regular-expression ]
display ip https [ | { begin | exclude |
include } regular-expression ]
45
Remarks
By default, the HTTPS service is not
associated with any ACL.
Associating the HTTPS service with an
ACL enables the device to allow only
clients permitted by the ACL to access
the device.
N/A
By default, no password is configured
for the local user.
By default, no command level is
configured for the local user.
By default, no service type is configured
for the local user.
N/A
If the VLAN interface already exists, the
command enters its view.
By default, the IP address of
VLAN-interface 1 is 192.168.0.100.
Remarks
Available in any view.
Available in any view.
Available in any view.
Hide quick links:
Advertisement
Table of Contents
