HP 830 Series Configuration Manual page 40
Poe+ unified wired-wlan switch
Hide thumbs
Also See for 830 Series:
- Configuration manual (530 pages) ,
- Command reference manual (136 pages) ,
- Installation manual (58 pages)
Table of Contents
Advertisement
Step
4.
Enable scheme
authentication.
5.
Enable command
authorization.
6.
Enable command
accounting.
7.
Exit to system view.
8.
Apply an AAA
authentication scheme to
the intended domain.
9.
Create a local user and
enter local user view.
10.
Set a password.
11.
Specify the command
level of the local user.
12.
Specify Telnet service for
the local user.
13.
Exit to system view.
14.
Configure common
settings for VTY user
interfaces.
As shown in
Figure 1
1, the next time you attempt to Telnet to the CLI, you must provide the configured
login username and password. If you are required to pass a second authentication, you must also
provide the correct password to access the CLI. If the maximum number of login users has been reached,
your login attempt fails, and the message "All user interfaces are used, please try later!" appears.
Command
authentication-mode scheme
command authorization
command accounting
quit
a.
Enter ISP domain view:
domain domain-name
b.
Apply an AAA scheme to
the domain:
authentication default
{ hwtacacs-scheme
hwtacacs-scheme-name
[ local ] | local | none |
radius-scheme
radius-scheme-name
[ local ] }
c.
Exit to system view:
quit
local-user user-name
password { cipher | simple }
password
authorization-attribute level level
service-type telnet
quit
See
"Configuring common VTY user
interface settings
(optional)."
34
Remarks
Whether local, RADIUS, or
HWTACACS authentication is adopted
depends on the configured AAA
scheme.
By default, local authentication is
adopted.
Optional.
By default, command authorization is
disabled. The commands available for
a user depend only on the user
privilege level.
Optional.
By default, command accounting is
disabled. The accounting server does
not record the commands executed by
users.
N/A
Optional.
By default, local authentication is used.
For local authentication, configure
local user accounts.
For RADIUS or HWTACACS
authentication, configure the RADIUS
or HWTACACS scheme on the device
and configure authentication settings
(including the username and
password) on the server.
For more information about AAA
configuration, see Security
Configuration Guide.
N/A
By default, no password is set.
Optional.
By default, the command level is 0.
By default, no service type is specified.
N/A
Optional.
Hide quick links:
Advertisement
Table of Contents
