Logging in to the Web interface
The 10500/7500 20G unified wired-WLAN module provides a built-in Web server for you to configure
it through a Web browser.
The HP 830 Series PoE+ unified wired-WLAN switch provides two built-in Web servers: one on the
access controller engine, and one on the switching engine. For information about how to log in to the
Web interface of the switching engine, see HP 830 Series PoE+ Unified Wired-WLAN Switch Switching
Engine Fundamentals Configuration Guide.
Web login is enabled by default. The default login settings are as follows:
IP address—192.168.0.100/24. (The management interface has no IP address by default.)
•
Username—admin.
•
•
Password—admin.
The device supports HTTP 1.0 and HTTPS for transferring webpage data across the Internet.
HTTPS uses SSL to encrypt data between the client and the server for data integrity and security, and is
more secure than HTTP. You can define a certificate attribute-based access control policy to allow only
legal clients to access the device.
HTTP login and HTTPS login are separate login methods. To use HTTPS login, you do not need to
configure HTTP login.
Table 17
shows the basic Web login configuration requirements.
Table 17 Basic Web login configuration requirements
Object
Device
PC
Configuring HTTP login
Step
1.
Enter system view.
2.
Enable the HTTP service.
Requirements
Assign an IP address to a Layer 3 interface.
Configure routes to make sure the interface and the PC can reach each other.
Perform either or both of the following tasks:
•
Configuring HTTP login
•
Configuring HTTPS login
Install a Web browser.
Obtain the IP address of the device's Layer 3 interface.
Command
system-view
ip http enable
42
Remarks
N/A
By default, HTTP service is
enabled.