Canon ImageRUNNER 2545i Sending And Facsimile Manual page 283
Hide thumbs
Also See for ImageRUNNER 2545i:
- System settings manual (314 pages) ,
- Reference manual (264 pages) ,
- Printer manual (148 pages)
Table of Contents
Advertisement
Check the user name and password or check settings.
Cause 1
Remedy
Cause 2
Remedy
No response.
Cause 1
Remedy
Cause 2
Remedy
Cause 3
Remedy
9
No response from the server. Check the settings.
Cause
Remedy
Out of resources. Wait for a moment, then perform operation again.
Cause
Remedy
9-8
Self-diagnostic Display
The user name, password, or server name for access to Authorized Send is
incorrect.
Make sure that the specified user name, password, and server name are
correct.
The user attribute name, administrator's ID, or password for access to
Authorized Send is incorrect.
Check that <Attribute of User Name>, <User Name>, and <Password> on the
LDAP Authentication Server Settings page are set correctly. (See Chapter 4,
"Customizing Settings," in the Remote UI Guide.)
The server was not running when you tried to send.
Check the destination.
The network connection was lost when you tried to send. (Either you could not
connect to the destination or the connection was lost before the job could
complete.)
Check the status of the network.
A TCP/IP error occurred when you tried to send an e-mail or I-fax.
Check that the network cables and connectors are properly connected.
The specified server settings are incorrect, or the server is not turned ON.
Alternatively, the machine's TCP/IP resources may be low.
Wait for a while, and try browsing again. If you still fail, try selecting another
server.
You cannot browse the network due to a lack of TCP/IP resources. This may be
because documents have just been continuously sent or are being continuously
sent through FTP or Windows (SMB).
Wait for a while, and try browsing again.
Hide quick links:
Advertisement
Table of Contents
