Removing Base Station(S); Changing The Primary Base Station - Toshiba IP4100 Installation Manual
Hide thumbs
Also See for IP4100:
- User manual (23 pages) ,
- User manual (36 pages) ,
- Product bulletin (20 pages)
Table of Contents
Advertisement
REMOVING BASE STATION(S)
REMOVING BASE
STATION(S)
CHANGING THE PRIMARY
BASE STATION
IP4100 Install Sept., 2013
Before removing the primary base station from the system, configure a
different base station to be the primary synchronization source (refer to
"CHANGING THE PRIMARY BASE STATION"
Important!
Never default or remove a base station from a chain with
an ID of 0 (or RPN00), or the chain will have to be rebuilt.
1. Login to a base station other than the one you want to remove from
the system.
2. Go to the Multi Cell screen and view the Base Station Group table.
Note the RPN number of the base station to be removed.
3. Check the Extensions screen to see if any extensions are registered
to the base station to be removed. The State column displays which
base station the handset extensions are registered.
4. Physically move the handsets registered to those extensions out of
this base station's coverage area and place them next to a different
base station. Wait for the handsets to change their registration to the
new base station. Alternatively, power off the handsets, and power
them on near the different base station.
5. In the Base Station Group table, check to see if the base station you
want to remove is serving as the synchronization source for any other
base station(s). If necessary, select a new DECT sync source for any
affected base stations, and click Save.
6. Click the check box beside the base station you want to remove from
this chain, then click Remove from chain. (Be sure you do not check
the base station with ID 0/RPN00.)
7. Login to the base station just removed. On the Home/Status screen,
verify that it reads Multi Cell disabled on the System Information line
8. For use in another chain, reset the base station to its factory default
settings (go to the Management screen and click Default Base
Station).
When the base station finishes rebooting, login and check the Home/
Status screen. The base station name at the top of the screen should
read SME VoIP and the System Information field should still read
Multi cell Disabled.
9. Log out of the base station, and repeat this procedure on any other
base stations you want to remove from system.
This procedure is used to change the Primary Base Station of a chain.
Important!
Only perform this procedure when the system is offline or
in a maintenance period.
1. Log in to a base station in the chain.
2. Go to the Multi Cell screen.
3. In the Base Station Group table, determine which base station you
want to become the new primary base station.
4. Select this base station's own RPN as the DECT Sync Source.
Configure Level 2 (and Up) Base Stations
on
page
1-29).
1-29
Hide quick links:
Advertisement
Table of Contents
